A-Plus PowerRoof® is a premium pure acrylic water-based roofing paint designed to provide excellent beautification and protection for roofs. The paint dries to a glossy, tough, durable, and dirt-resisting finish. It can be applied on most common roof materials like galvanized iron sheets and cementitious roof tiles. It also has heat reflective properties which helps minimize transfer of solar heat to the house’s interiors.
☑100% Premium Acrylic Roofing Paint
☑Excellent Weatherability & Ultraviolet Resistance
☑Fast Drying High-Gloss Durable Finish
☑Very Good Color Retention and Adhesion
☑Excellent Dirt Pick-Up Resistance, Easy to Clean
☑Easy to Apply, Lead-Free, Environment Friendly Paint
☑Available in 16 Factory-Mixed Colors
Specifications
Principal Uses: Exterior Galvanized Iron surfaces, pre-painted Galvanized Sheets, Asphalt Shingles, Unglazed and Cementitious Roof Tiles, etc.
Sheen: Gloss
Coverage: 25-30 sqm per gallon / coat
Surface Dry: 30 mins – 1hr
Recoat Interval: 1 – 2 hrs
Dry Through: 2 – 3 hrs
Thinning: Use as supplied. Thinning is not recommended as it may affect paint properties.
Clean-up Solvent: Water
Application: Brush, Roller, or Spray
Packaging: 4L, 16L plastic containers
*Available in 15 factory mixed colors
Surface Preparation & Precautions
- Surface to be painted must be thoroughly cleaned, free from any contaminants. Avoid painting under extreme environmental conditions and/or bad weather conditions.
- If painting over new concrete, it must be allowed to cure for at least four weeks. Otherwise, apply A-Plus® Concrete Sealer before painting.
- If previously painted, strip off all paint to bare substrate with A-Plus Supertanggal® Paint Remover.
- New galvanized surfaces must be wiped with paint thinner and sanded to improve paint adhesion. Non-galvanized or rusting metal roof sheets should be treated and sanded clean with A-Plus® Rust Converter and pre-painted with at least 2 coats of a good anti-corrosive metal primer such as A-Plus PowerRoof® Anti-Corrosive Primer, Glazer Galva-Plus® Epoxy Primer, or A-Plus® Metal Primer Red Oxide.
Painting Procedure
Painting Procedure on Metal Substrate:
- If previously painted, strip off all loose and chalking paint. If rust is present, sand with large grit sandpaper while applying A-Plus® Rust Converter to roughen surface.
- Primer: Un-Galvanized or rusted metal roof sheets should be pre-painted with at least 2 coats of A-Plus PowerRoof® Anti-Corrosive Primer or Glazer Galva-Plus® Epoxy Primer.
- Topcoat: Apply 2-3 coats of your choice color of A-Plus PowerRoof®. Allow 2-3 hours drying time between each coat.
Painting Procedure on Cementitious Roofing:
- If previously painted, strip off all loose and chalking paint and sand to roughen surface.
- Waterproofing: Observe proper concrete curing schedule. For positive side waterproofing on areas such as roofdecks, etc., apply 3-4 coats of a mixture of A-Plus® Concrete Bond with portland cement at 1-Ltr to 1-Kg ratio. Pot life is approx 4 hours. Allow 2-3 hours drying between each coat. For superior waterproofing on both positive and negative side water pressure, apply 2-3 coats of A-Plus Water-Check®.
- Topcoat: Apply 2-3 coats of your choice color of A-Plus PowerRoof®. Allow 2-3 hours drying time between each coat.
COLOR SWATCHES
-
1815
LAGUNA WHITE -
1827
SAMAR BEIGE® -
1847
TERRA COTTA -
1862
MOROCCO BLUE -
1845
CANYON RED -
1852
BAGUIO GREEN -
1846
SPANISH RED -
1823
VANILLA SKY -
1842
SANTANA RED -
1832
PANDORA -
1868
OCEANIC BLUE -
1848
LUCKY MOCHA -
1843
GRAND PAVILION -
1849
CLASSIC BROWN -
1858
HEALTHY GREEN
Related products
Decorative
Decorative
Decorative
Decorative
Decorative
Decorative
