A-Plus® NC Lacquer Dead Flat Clear is a premium Nitrocellulose-based, flat lacquer varnish that has high build properties and dries to a hard durable film. It is ideal for interior sealed wood such as furnitures, fixtures, cabinets, doors, panels, and many more.
☑Premium Fast-Drying Lacquer-Based Varnish
☑Flat Finish High Build Coating
☑Smooth, Dust-Free Finish
☑Superior Durability and Adhesion
☑Resists Cracking and Peeling
☑Easy to Use, Lead-Free
Specifications
Principal Uses: For interior sealed wood such as furnitures, fixtures, cabinets, doors, panels, and many more.
Sheen: Flat
Coverage: 25-30 square meter per gallon / coat
Surface Dry: 10 minutes
Recoat Interval: 30 minutes
Dry Through: 1 hr
Thinning and Clean Up: A-Plus® PG Lacquer Thinner
Application: Brush or Spray
Packaging: 1L, 4L
Surface Preparation & Precautions
- Ensure wood material is fully kiln dried/treated.
- If previously painted, strip off all loose and chalking paint with A-Plus Supertanggal® Paint Remover. If necessary, remove wood discoloration by applying A-Plus® Wood Bleach #1 & #2.
- Sand surface smooth to eliminate surface imperfections. Correct surface imperfections using A-Plus® NC Lacquer Spot Putty or A-Plus® Fast-Drying Plastic Wood Filler.
- Surface to be applied on must be thoroughly cleaned, free of any contaminants that can affect adhesion such as wax, oil, grease, moisture, and loose particles.
- Avoid painting under extreme environmental conditions and/ or bad weather conditions.
Painting Procedure
New Wood:
- Stain (optional): Apply A-Plus® Penetrating Wood Stain using either brush or spray.
- Sealer Coat: Apply at least 2 coats of A-Plus® NC Lacquer Sanding Sealer. Sand lightly(#220/#440) before topcoat application. Allow at least 1 hr drying before putty.
- Putty: Correct surface imperfections (especially for open grain wood) using A-Plus® Fast-Drying Plastic Wood Filler. If necessary, tint with A-Plus® Penetrating Wood Stain. Allow to cure for at least 2 hours before sanding and applying another coat of A-Plus® NC Lacquer Sanding Sealer then sand again.
- Final coat: Apply at least 2 coats of A-Plus® NC Lacquer Dead Flat Clear. Perform sufficient sanding in between each coat.
Repainting:
- Strip off old paint using A-Plus Supertanggal® Paint Remover. If old lacquer finish is in good condition, sand surface.
- Make sure surface is clean and dry before applying A-Plus® NC Lacquer Dead Flat Clear. Apply at least 2 coats.
(Note: 10% by volume of A-Plus® PG Lacquer Flo is added to the varnish mixture just before application to prevent moisture blushing)
Related products
Industrial
Woodcraft
Woodcraft
Woodcraft
Woodcraft
Construction Chemicals
