A-Plus® Concrete Putty is a high-solids, water-based, masonry putty used for interior/exterior correcting of minor surface imperfections up to 2mm. It cures fast, exhibits excellent adhesion and has good sanding properties.
Specifications
Principal Uses: Ideal for interior concrete, precast, stucco, and new plaster
Coverage: Full Putty: 10-12sqm per gallon
Spot Putty: 25sqm per gallon
Surface Dry: 30 mins
Recoat Interval: 2 hrs
Dry Through: 2 hrs
Clean-up Solvent: Water
Application: Putty Knife/Mortar Gun
Packaging: 1L, 4L
Surface Preparation & Precautions
1. Surface to be painted must be thoroughly cleaned, free of any contaminants.
2. For fresh concrete, apply at least 1 coat of A-Plus® Concrete Sealer.
3. Structural defects like leaks and all sources of internal water pressure must be thoroughly sealed and repaired to prevent membrane damage.
4. If previously painted, strip off all loose and chalking paint with A-Plus Supertanggal® Paint Remover.
5. Avoid applying under extreme environmental conditions and/or bad weather conditions.
6. Do not intermix with other paint systems in order to preserve optimum product properties.
7. MIX WELL before using.
Painting Procedure
1. Follow proper surface preparation for new concrete.
2. For fresh concrete, apply at least 1 coat of A-Plus® Concrete Sealer.
3. Make sure surface is clean and dirt-free. Dampen surface using a rag/sponge soaked in water.
4. Mix product thoroughly before using. Apply the slurry using a clean and smooth steel trowel or spatula. Press firmly for an even and thin coat. Recommended thickness is 0.5 to 2.0mm.
5. Allow the surface to dry for at least an hour before sanding. Allow sufficient drying time before painting.
Suggested Painting System on Concrete Surfaces:
1. Sealer: Observe proper concrete curing schedule. Apply A-Plus® Concrete Sealer using either brush or roller. (Skip this step if waterproofing will be applied)
2. Waterproofing: If concrete surface is heavily exposed to water (ex. firewalls, bathroom walls), apply at least 2 coats of A-Plus Water-Check®.
3. Primer: Apply at least 1-2 coats of A-Plus® Premium Acrylic Flat Latex as primer.
4. Putty: Repair all minor cracks and surface imperfections with A-Plus® Concrete Putty. For a luxuriously smooth finish, apply A-Plus® Skim Coat 501/503.
5. Topcoat: Apply 1-2 coats of your choice color of A-Plus All Weather® Paint. Allow 2-3 hours drying time between each coat.
Related products
Construction Chemicals
Wall and Surface Preparation
Wall and Surface Preparation
Wall and Surface Preparation
Wall and Surface Preparation
Construction Chemicals
Construction Chemicals
Wall and Surface Preparation