A-Plus® Concrete Bond is a premium heavy-duty acrylic polymer based cement modifier formulated for positive side waterproofing. It is highly recommended for both horizontal and vertical surfaces like roof decks, basements, bathroom floorings, firewalls, water tanks, and many more. It cures to become an integral part of the concrete, thus providing a strong and durable, UV resistant, impenetrable waterproofing membrane that prevents water seepage and reinforces concrete strength.
☑Heavy-Duty 2K Positive Side Waterproofing
☑Long Term Waterproofing Solution
☑Flexible, Weathering and UV Resistant
☑Completely Seals Off Moisture and Water
☑Does Not Crack, Fade, or Debond
☑Low VOC, Environment Friendly
Specifications
Principal Uses: Highly recommended for both horizontal and vertical surfaces like Firewalls, Roof decks, Basements, Bathroom Floorings, Water Tanks, Gutters, Downspouts, and many more.
Coverage: 5-8 sqm *Depending on surface texture and porosity
Mixing Ratio: 1-Ltr to 1-Kg Portland cement
Surface Dry: 2hrs
Recoat Interval: 2 – 3 hrs (Allow to dry for at least overnight before painting)
Dry Through: Overnight
Thinning: If necessary, thin with water to adjust desired consistency.
Application: Brush/Roller
Packaging: 4L, 16L
Pot life: 4 hrs
Surface Preparation & Precautions
- Surface to be painted must be thoroughly cleaned, free of any contaminants.
- For fresh concrete, apply at least 2 coats of A-Plus® Concrete Sealer.
- Structural defects like leaks and all sources of internal water pressure must be thoroughly sealed and repaired to prevent membrane damage.
- Avoid painting under extreme environmental conditions and/or bad weather conditions.
- Mix well before using.
Painting Procedure
General Application Procedure for Normal Substrates with No Damage:
- Thoroughly clean the surface prior to application. Pre-wet surface with water to improve adhesion.
- Prepare a lump-free slurry of cement by mixing A-Plus® Concrete Bond with portland cement at ratio: 1-Ltr to 1-Kg. Pot life of mixture is approximately 4 hours after mixing.
- Apply first coat mixture using stiff brush. Succeeding coats may be applied using a heavy roller. Repeat up to 3-4 number of coats and allow 2-3 hours drying in-between coats. Allow to cure at least 48 hours before subjecting to water flooding test or before applying paint or concrete topping.
Procedure for Damaged Substrates (with cracks and other surface imperfections):
- Mix A-Plus® Concrete Bond with portland cement at ratio: 1-Ltr to 3-Kg. The ratio can be varied slightly to achieve desired consistency. Mix thoroughly until a smooth consistency is achieved. Pot life of mixture is approximately 4 hours after mixing.
- Apply the mixture on the affected areas using a trowel or putty knife. Let cure for 2 hours before applying succeeding coats of A-Plus® Concrete Bond cement slurry.
- If higher strength repair is required, apply a mixture of A-Plus Procrete® High Viscosity Construction Epoxy for patching larger-sized concrete imperfections covering smaller areas.
- After patching surface imperfections, apply normal cement slurry of A-Plus® Concrete Bond and portland cement with ratio: 1-Ltr to 1-Kg using a stiff brush and heavy roller.
Related products
Decorative
Decorative
Waterproofing
Decorative
Waterproofing